Optimum OCPN/OP connections ?

[affinite]

Is it just a case of putting "nmea0183" in the input event for the radio ? 
I tried it but I dont see the data when I look at the SK Log for that event, (next test is to connect a serial test device to see if there is actual data on the serial port (even if not on the SK log)

or do I need to route it using the "Forward and filter NMEA to NMEA" plugin ?

Here's how I do it >> On the gps connection set an input event called gps-nmea. 



Then I use a usb/serial which inputs wind data as an output for gps data which gets sent out on pin 3 of the wind serial/usb at 4800baud

Thanks - I think the fog is slowly lifting but I still get mixed up with SK Input and Output events ...
Does your "wind" device also have a NMEA repeater / autopilot attached ?
I dont understand why you'd send gps data to your wind instruments ?