This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
No communication between RPi and Nano using pypilot service
1) clutch pwm is normally set from pypilot so this setting you can change from web etc (unless old version and uses this default)
2) the service may run it as a user that has wrong permissions to access usb ?
3) the range in RC mode or hbridge mode is 0-1.1v not 0-3.3v for ratiometric mode 0-5

if you are really running the nano at 3v3 that would be very odd. It is running at 5 volts correct?

4 depending on mode (described in comment), for hbridge try d2 and d3

Messages In This Thread
RE: No communication between RPi and Nano using pypilot service - by seandepagnier - 2022-07-21, 04:33 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)