2022-12-12, 05:15 AM
Hello all
I am having trouble with compass calibration changing after the pypilot service is shut down and restarted or rebooted.
My updated system is RPi4 running Bullseye 32bit OS, OpenCPN 5.6.2, pypilot 0.35 and pypilot_pi 0.34.4.0 but had a similar issue on an older Buster 32 installation. Note no Openplotter.
At the moment I have the system off the boat for updating and testing. To replicate, start, set level and calibrate the compass. IMU is ICM20948 and calibration seems ok without additional work. Note heading and leave in that position. Stop pypilot.service or reboot, note heading not the same. Typical numbers 347 deg after calibration, 298 deg after restart, so close to 50 deg different. Also, rotating the unit to approximate NESW positions, after calibration the implied offset is within 6 deg on the 4 points so quite reasonable, after restart, the implied offset varied from -64 to +13, so very wayward.
Checking the pypilot.conf file, there was no difference between the compass calibration points in the files after calibration to that after restarting. To check there wasn't a permission issue, I deleted the ,conf file and redid the comparison. The compass calibration points recorded were not the same as the deleted file but the same on the before and after test. My conclusion is that the calibration is not being read from the file after restarting. This is consistent with my most recent experience on the water.
Any ideas?
John
I am having trouble with compass calibration changing after the pypilot service is shut down and restarted or rebooted.
My updated system is RPi4 running Bullseye 32bit OS, OpenCPN 5.6.2, pypilot 0.35 and pypilot_pi 0.34.4.0 but had a similar issue on an older Buster 32 installation. Note no Openplotter.
At the moment I have the system off the boat for updating and testing. To replicate, start, set level and calibrate the compass. IMU is ICM20948 and calibration seems ok without additional work. Note heading and leave in that position. Stop pypilot.service or reboot, note heading not the same. Typical numbers 347 deg after calibration, 298 deg after restart, so close to 50 deg different. Also, rotating the unit to approximate NESW positions, after calibration the implied offset is within 6 deg on the 4 points so quite reasonable, after restart, the implied offset varied from -64 to +13, so very wayward.
Checking the pypilot.conf file, there was no difference between the compass calibration points in the files after calibration to that after restarting. To check there wasn't a permission issue, I deleted the ,conf file and redid the comparison. The compass calibration points recorded were not the same as the deleted file but the same on the before and after test. My conclusion is that the calibration is not being read from the file after restarting. This is consistent with my most recent experience on the water.
Any ideas?
John