This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pypilot and existing equipment
#3
(2022-08-10, 03:11 PM)seandepagnier Wrote: Yes it will work with a reversing pump.

As for using raymarine chartplotter... The level of integration will never be as good as OpenCPN which has a pypilot plugin, but if it can  send/receive nmea0183 it can share sensor data like gps, wind, etc and follow routes.

For components check:
https://github.com/pypilot/workbook/wiki

You need interntial sensors recommend mpu9255 or icm20948 as well as a motor controller for a minimal setup.

Excellent, thank you very much. I am not so concerned about Raymarine integration, I can always share routes between Openplotter and the Axiom. 
I have been mucking about with my raspberry pi for a while now and think I can handle this. It's either that or try to figure out what is wrong with the Comnav... again.

I appreciate your response, Cheers!
Reply


Messages In This Thread
RE: Pypilot and existing equipment - by Sailing Infidel - 2022-08-10, 04:42 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)