This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Reset calibration
#2
I really dont know but it could be a sensor glitch. This meaning the sensors for odd reason (cosmic ray? heh) start outputing strange values for a while.

Keep us posted, and for ultimate reliability have two systems that can swap... If you can take note of the raw calibration values for compass and accel, and maybe even the gyro bias. Then compare these over time. The results could help make the program smarter.

Already the driver has special logic to reset the sensors in cases where the data seems very wrong and this usually fixed the problem (so I thought) which was somewhat rare and difficult to reproduce but I was able to (by plugging/unplugging i2c enough times randomly), So although this problem should not actually ever occur.. it does but may be a different problem, or maybe the same but just not quite bad enough to trigger the reset.
Reply


Messages In This Thread
Reset calibration - by ironman - 2022-08-11, 11:32 AM
RE: Reset calibration - by seandepagnier - 2022-08-12, 02:31 AM
RE: Reset calibration - by ironman - 2022-11-04, 07:15 PM
RE: Reset calibration - by Ebraball - 2022-11-04, 07:32 PM
RE: Reset calibration - by ironman - 2022-11-15, 10:46 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)