This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Problem with i2c: enabled | not running
#7
Hi:
NOOB HERE...
I have been wrestling with the BME280 - connected via a FT232H (USB C). and getting:
Checking I2C sensors... | I2C enabled | Access to Signal K server validated
↳openplotter-i2c-read not running
The log shows - BME280 read error: You must first call bme280.ini()

Where do I add this?
Thx.
Reply


Messages In This Thread
Problem with i2c: enabled | not running - by kste - 2022-08-31, 10:02 PM
RE: Problem with i2c: enabled | not running - by jmbwind - 2022-12-29, 10:46 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)