Openplotter 3 64 bit - No Seatalk1, GPIO app unavailable.

[broosmaxim]

It gets weirder with more trying:

So at home (testbench) it also stopped working at some point. So i went back to square one:

- uninstalled openplotter gpio
- rebooted
- installed openplotter gpio
- added seatalk1 connection
- seatlk signal gets picked up in Signalk, all good
- reboot the raspi from the menu
- seatalk stills shows up in Signalk after reboot
- switch off the raspi from the menu
- disconnect power from raspi
- restore power, raspi boots up
- NO MORE SEATALK SHOWING UP… (also not after some more rebooting, power off/on,…)

?

All this time, nothing on the circuit has changed, the seatlk1 device has had power the whole time.

I’m might later try a clean install of openplotter, maybe i did too much messing around…