This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
OpenPlotter I2C 3.x.x - INA219 settings

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
OpenPlotter I2C 3.x.x - INA219 settings
Sailoog Offline
Administrator
*******
Posts: 2,850
Threads: 59
Joined: Mar 2016
Reputation: 267
#11
2022-11-25, 09:55 PM
Done. The default mode is still set_calibration_32V_2A because set_calibration_16V_5A assumes a shunt resistor of 0.02 ohm and most modules have a 0.1 ohm resistor.

   

I do not have a INA219 so this has been blind development. It is not tested, just no coding errors. Test and report please, thanks.
Find
Reply


Messages In This Thread
RE: I2C INA 3.1.0 Settings - by tobias.e - 2022-11-12, 08:03 PM
RE: I2C INA 3.1.0 Settings - by Sailoog - 2022-11-12, 08:23 PM
RE: I2C INA 3.1.0 Settings - by tobias.e - 2022-11-12, 09:55 PM
RE: I2C INA 3.1.0 Settings - by RichFind - 2022-11-14, 03:31 AM
RE: OpenPlotter I2C 3.x.x - INA219 settings - by Sailoog - 2022-11-25, 09:55 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)