This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
OpenPlotter I2C 3.x.x - INA219 settings

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
OpenPlotter I2C 3.x.x - INA219 settings
tobias.e Offline
Junior Member
**
Posts: 48
Threads: 8
Joined: Jan 2021
Reputation: 2
#18
2022-11-30, 09:10 PM
Raw Voltages are fine, raw current and power seem to be in mA and mW, respectively.

for roughly half an Ampere, the Shunt voltage is 3 to 4 mV, that may well be interpreted as null. I'll try a setup with lager currents this weekend.
Find
Reply


Messages In This Thread
RE: I2C INA 3.1.0 Settings - by tobias.e - 2022-11-12, 08:03 PM
RE: I2C INA 3.1.0 Settings - by Sailoog - 2022-11-12, 08:23 PM
RE: I2C INA 3.1.0 Settings - by tobias.e - 2022-11-12, 09:55 PM
RE: I2C INA 3.1.0 Settings - by RichFind - 2022-11-14, 03:31 AM
RE: OpenPlotter I2C 3.x.x - INA219 settings - by tobias.e - 2022-11-30, 09:10 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)