2022-11-24, 11:51 PM
(This post was last modified: 2022-11-25, 11:58 AM by Ebraball.
Edit Reason: keyboard photo was not saved
)
Good evening Marco, first of all, my apologies for the long delay in answering you, but I had minor health problems that kept me away from the boat and the internet. The manipulations that I mentioned in the previous message work perfectly, I perfectly found the ergonomics of my ST3000. It's true that I'm looking for the difficulty by wanting to use a wired keyboard at all costs, but it is the most ergonomic solution for my boat. I want to reproduce the current configuration where you can see in the photos that the white-gray command (Autohelm tinkered by me) in the entrance is accessible both from the chart table with the computer inside and from the winches from outside, for tacking. I'm replacing the old ThinkPad shown in the picture with a Raspberry Pi 4, and I want to replace the Autohelm with Pypilot. For the moment, despite my very limited knowledge, it seems to me that I am on the right track thanks to you. I really want to thank you for sharing Ray.py which really meets my needs. I'm now trying to integrate GPS, IMU and all NMEA 0183 data (Wind, depth, etc) into OpenCPN, but I'm struggling a bit!
The prototype of the keyboard, which works perfectly…
The prototype of the keyboard, which works perfectly…