2023-04-28, 08:48 PM
I've just joined the forum and can't see a button to start a new thread for this so please correct me if I'm missing something.
I have a working pypilot with the small motor controller and I want to use a Devantech MD03 that I already have to drive a larger motor.
I have bought an Arduino clone as suggested and installed motor.ino and crc.h on it and connected the serial output of the pypilot to it through a level converter but I am not seeing the tx or rx led flashing.
Am I missing something, I read about settings on cheap nano's being incorrect but that is beyond my experience.
As I say the serial data works perfectly on the existing motor controller.
I have a working pypilot with the small motor controller and I want to use a Devantech MD03 that I already have to drive a larger motor.
I have bought an Arduino clone as suggested and installed motor.ino and crc.h on it and connected the serial output of the pypilot to it through a level converter but I am not seeing the tx or rx led flashing.
Am I missing something, I read about settings on cheap nano's being incorrect but that is beyond my experience.
As I say the serial data works perfectly on the existing motor controller.