2023-03-15, 11:39 AM
The steps are:
1)Buy the board i mention
2)upload the bin file Sean posted in the thread i mention in the last page
3)with the esp connected to the pc navigate to the hat directory and run 'make upload'. This will copy the necessary files to the esp.
4) look in the config_esp32.py file how to wire the buttons or change to your requirements and the upload again if changed
Everything is ready.
I havent real time tested this but works flawlesly in the bench
1)Buy the board i mention
2)upload the bin file Sean posted in the thread i mention in the last page
3)with the esp connected to the pc navigate to the hat directory and run 'make upload'. This will copy the necessary files to the esp.
4) look in the config_esp32.py file how to wire the buttons or change to your requirements and the upload again if changed
Everything is ready.
I havent real time tested this but works flawlesly in the bench