This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
OP3 windtrim Navman/raymarine
#2
I assume you want to use the /dev/ttyOP_pilotout device to send data. You need to add the event nmea0183out in the field "Output events" of your signal k connection for this device.

when you set a serial connection in signal k, it works only as input by default, if you want it to work as output too, you need to tell the Signal k server what events you want to send. Events are like "labels", you can label any data entry (event) and then use that label to identify the data and define outputs. Events explained: https://openplotter.readthedocs.io/en/3....exing.html
Reply


Messages In This Thread
OP3 windtrim Navman/raymarine - by cepicscepics - 2023-01-25, 02:17 AM
RE: OP3 windtrim Navman/raymarine - by Sailoog - 2023-01-25, 02:10 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)