2023-05-11, 12:04 PM
Hello,
Literally just received my new PiCAN-M yesterday... following the SK-Pang manual to install and get it going on my Pi, I edited /boot/config.txt with the following:
enable_uart=1
dtparam=i2c_arm=on
dtparam=spi=on
dtoverlay=mcp2515-can0,oscillator=16000000,interrupt=25
dtoverlay=spi-bcm2835-overlay
dtoverlay=spi-bcm2835-overlay generated a "failed to load" message.
What was the resolution?
Literally just received my new PiCAN-M yesterday... following the SK-Pang manual to install and get it going on my Pi, I edited /boot/config.txt with the following:
enable_uart=1
dtparam=i2c_arm=on
dtparam=spi=on
dtoverlay=mcp2515-can0,oscillator=16000000,interrupt=25
dtoverlay=spi-bcm2835-overlay
dtoverlay=spi-bcm2835-overlay generated a "failed to load" message.
What was the resolution?