Hi, I am currently trying to operate my Tinypilot (equipment sold by Sean D'Epagnier, based on Raspi zero wifi) with wired Ethernet link, I have opened a thread on this question. I am not really experimented with Raspberry and Linux, but to operate a USB to Ethernet adapter you need to install a dedicated extension as I have tried to explain in this thread.
- Paste the extension net-usb-4.9.22.tcz (repo.tinycorelinux.net/9.x/armv6/tcz/net-usb-4.9.22-piCore.tcz) in /mnt/mmcblk0p2/tce/ on the Tinypilot Raspberry,
- create the file "onboot.lst" in /mnt/mmcblk0p2/optional/
- add with sudo nano the line "net-usb-KERNEL.tcz" in onboot.lst
- run the command tce-load -i net-usb-KERNEL.tcz
- activate eth0 with sudo ifconfig eth0 xx.xx.xx.xx up (IP at your convenience)
- check with ipconfig
I am not absolutely sure of my procedure due to the lot of trials and errors to obtain the result and to my poor knowledge in programming but in case there will be somebody to correct it.
- Paste the extension net-usb-4.9.22.tcz (repo.tinycorelinux.net/9.x/armv6/tcz/net-usb-4.9.22-piCore.tcz) in /mnt/mmcblk0p2/tce/ on the Tinypilot Raspberry,
- create the file "onboot.lst" in /mnt/mmcblk0p2/optional/
- add with sudo nano the line "net-usb-KERNEL.tcz" in onboot.lst
- run the command tce-load -i net-usb-KERNEL.tcz
- activate eth0 with sudo ifconfig eth0 xx.xx.xx.xx up (IP at your convenience)
- check with ipconfig
I am not absolutely sure of my procedure due to the lot of trials and errors to obtain the result and to my poor knowledge in programming but in case there will be somebody to correct it.