This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Can you help me with my initial setup?
1) You might just locate the computer and controller nearby initially, 6-8 inches apart since the wires to the motor can affect the compass if routed in the worst possible way.

yes you can use ethernet wire for the data signal and power. You only need 4 of the 8 wires.

2) I would try without initially. 10 mm^2 wire is oversize, 2.5mm^2 is ok for wiper motor

3) It depends on factors like the boat, how you are sailing it and many more, so impossible to say.

Messages In This Thread
RE: Can you help me with my initial setup? - by seandepagnier - 2023-03-31, 07:31 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)