2023-06-01, 04:50 PM
Hi
I'm back on board testing the seatalk connection on the HAT this afternoon. With the new wiring, inverted and ST jumper set, the STLINK FAIL error doesn't occur (postive). However, although I get several variables coming through in Signal K, all of them are null values. I sat here for about 1/2 an hour and nothing.
I then put the wiring back and removed the invert signal, the STLINK FAIL error came back on the autohelm but all the data for the wind and tridata instruments started to appear...
I forgot to bring down my resistor pack so I can't test the resistor and the old wiring at the moment.
Hope that helps
I'm back on board testing the seatalk connection on the HAT this afternoon. With the new wiring, inverted and ST jumper set, the STLINK FAIL error doesn't occur (postive). However, although I get several variables coming through in Signal K, all of them are null values. I sat here for about 1/2 an hour and nothing.
I then put the wiring back and removed the invert signal, the STLINK FAIL error came back on the autohelm but all the data for the wind and tridata instruments started to appear...
I forgot to bring down my resistor pack so I can't test the resistor and the old wiring at the moment.
Hope that helps