2023-05-17, 03:37 PM
Hello to everyone,
i have connected mpu9250 to the raspberry and everythings work greet. Sensor has been reconized and pypilot works correctly.
From the datasheet of this sensor i have:
Pin Description
VCC-> Supply Voltage (3 – 5VDC)
GND-> Ground
SCL/SCLK-> I2C Serial Clock / SPI Serial Clock
SDA/SDI-> I2C Serial Data / SPI Serial Data Input (MOSI)
EDA-> I2C Serial Data for External Sensor Connection
ECL-> I2C Serial Clock for External Sensor Connection
AD0/SDO-> I2C Slave Address LSB / SPI Serial Data Output (MISO)
INT-> Interrupt Digital Output (Totem Pole or Open-Drain)
NCS-> Chip Select (SPI Only)
FSYNC-> Frame Sync Digital Input (Ground if not used)
I'm trying to connect bmp280 to the eda and ecl but i don't have any value in signalk.
I try different channel for the bmp280 in the 12c software that correctly show 0x68 as address, but i don't have any value in signalk.
What i have to try?
i have connected mpu9250 to the raspberry and everythings work greet. Sensor has been reconized and pypilot works correctly.
From the datasheet of this sensor i have:
Pin Description
VCC-> Supply Voltage (3 – 5VDC)
GND-> Ground
SCL/SCLK-> I2C Serial Clock / SPI Serial Clock
SDA/SDI-> I2C Serial Data / SPI Serial Data Input (MOSI)
EDA-> I2C Serial Data for External Sensor Connection
ECL-> I2C Serial Clock for External Sensor Connection
AD0/SDO-> I2C Slave Address LSB / SPI Serial Data Output (MISO)
INT-> Interrupt Digital Output (Totem Pole or Open-Drain)
NCS-> Chip Select (SPI Only)
FSYNC-> Frame Sync Digital Input (Ground if not used)
I'm trying to connect bmp280 to the eda and ecl but i don't have any value in signalk.
I try different channel for the bmp280 in the 12c software that correctly show 0x68 as address, but i don't have any value in signalk.
What i have to try?