This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › General discussion v
Heel shows in inspector but not in opencpn?

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Heel shows in inspector but not in opencpn?
svsputnik1 Offline
Junior Member
**
Posts: 10
Threads: 6
Joined: Mar 2017
Reputation: 1
#1
2017-04-15, 05:17 PM
Hey guys

I have the BNO-055 sensor for magnetic and gyroscope.  The thing seems to be working as it is recognized by openplotter (see screenshot).  The data shows in the inspector (although I'm not sure I understand what it means) but if I add it in a dashboard in opencpn, it stays empty, even if I move the breadboard where the sensor is pinned for now.  Any idea of the missing link??

Thanks


Attached Files Image(s)
   
Find
Reply


Messages In This Thread
Heel shows in inspector but not in opencpn? - by svsputnik1 - 2017-04-15, 05:17 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)