2017-04-27, 07:37 AM
@PuddyB : quote .... I think you can make your own nmea 0183 sentence to check.
can you please guide on this to enable below:
in ocpn for air pressure the $xxMDA is used:
Code:
****MDA,x.x,I,x.x,B,x.x,C,x.x,C,x.x,x.x,x.x,C,x.x,T,x.x,M,x.x,N,x.x,M*hh<CR><LF>
** | | | | Dew point, degrees C
** | | | | Absolute humidity, percent
** | | | | Relative humidity, percent
** | | | | Water temperature, degrees C
** | | | | Air temperature, degrees C
** | | |----Barometric pressure, bars
** |----- Barometric pressure, inches of mercur
have found the NMEA generator in the menu but am stuck thereafter.
All I want is show the BMP180 value which is now submitted as XDR sentence, unfortunately ocpn does not recognize this but expects above.
can you please guide on this to enable below:
in ocpn for air pressure the $xxMDA is used:
Code:
****MDA,x.x,I,x.x,B,x.x,C,x.x,C,x.x,x.x,x.x,C,x.x,T,x.x,M,x.x,N,x.x,M*hh<CR><LF>
** | | | | Dew point, degrees C
** | | | | Absolute humidity, percent
** | | | | Relative humidity, percent
** | | | | Water temperature, degrees C
** | | | | Air temperature, degrees C
** | | |----Barometric pressure, bars
** |----- Barometric pressure, inches of mercur
have found the NMEA generator in the menu but am stuck thereafter.
All I want is show the BMP180 value which is now submitted as XDR sentence, unfortunately ocpn does not recognize this but expects above.