2023-06-13, 08:54 PM
I have a question on I2c connections. I have the i2c turned on in the pi, and installed from settings. Wanting to monitor inside temperature and humidity with a bmp 280.
Had it hooked up last year on the old version, got it set up but never got data. This year in version 3 the I2C setup page is dead. Have two different manufacturers sensors and both act the same.
just wondering if the I2C routine is not active yet, or I've made a mistake somewhere.
latest openplotter, Pi 4b, pi-can M hat now hooked up to the Pi.
Thanks
Alan
Had it hooked up last year on the old version, got it set up but never got data. This year in version 3 the I2C setup page is dead. Have two different manufacturers sensors and both act the same.
just wondering if the I2C routine is not active yet, or I've made a mistake somewhere.
latest openplotter, Pi 4b, pi-can M hat now hooked up to the Pi.
Thanks
Alan