2023-06-23, 08:52 AM
(This post was last modified: 2023-06-23, 09:22 AM by baltika_no_9.)
(2023-06-21, 10:09 PM)Polonioli Wrote:(2023-06-21, 09:57 PM)baltika_no_9 Wrote: Polonioli
OK so you know how to fix the problem with the USB GPS not being able to send data to signal K if you try to use "Remember Device", that's great. If you follow my advice you can overcome this and you will be able to use "Remember device".
You seem to be saying that there is problem with OpenCPN. I have not seen this problem so I am sorry I cannot help. If it is a problem with OpenCPN then perhaps ask for help on the OpenCPN forum (this one is for OpenPlotter).
Good luck
im think is openplotter because im clear device serial and opencpn works very fine and in other raspberry with openplotter v2 workfine opencpn with serial device add thank baltika
im solved the problem add usb serial with GPSD signalk and not SIGNALK , think is at problem with port 3000 have at problem , because gpsd change port for 2947 and work very fine
No,the problem is not with port 3000, that works perfectly well for Signal K. GPSD didn't "change" the port. GPSD uses 2947, Signal K uses 3000 - that is how the design works, they work very well independently as they can't share the same port.
The fact that you can add the serial device to gpsd is good news for you , well done. But it does not solve the problem. It works for GPS/AIS USB devices but not for others.
I have just tried a 32 bit system like yours and can confirm that downgrading udev and libudev1 from 247.3+rpi1-deb11u2 to 247.3+rpi1 does fix the problem.