This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › How do I...? v
SH-RPi V1 OP 3RPI 4 cant get 1W to work

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
SH-RPi V1 OP 3RPI 4 cant get 1W to work
leif_klasson@hotmail.com Offline
Junior Member
**
Posts: 24
Threads: 2
Joined: May 2019
Reputation: 0
#1
2023-06-21, 09:42 PM
Hi, I have an Rpi 4with Openplotter 3 installed. Tested and verified that it worked with 1W connection for 2 temp sensors, type DS18B20.
Worked as expected.

Then after installation of SH-Rpi hat V1 from hatlab, I can't get it to work.

I also have some ADS1115 on I2C, and these ones work as expected.

GPIO and 1W is enabled according to startup check. I have tried with removed the old 1W connections, but no new are popping up as before, and the old ones aren't working any more.

Any ideas?

/Leif
Find
Reply


Messages In This Thread
SH-RPi V1 OP 3RPI 4 cant get 1W to work - by leif_klasson@hotmail.com - 2023-06-21, 09:42 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)