2023-06-24, 05:10 PM
Have been using openplotter for a few years now. Have been playing with Op3 on a rpi4. After many attempts I have been unsuccessfull in getting my well used MPU9250 and my BME280 into Signal K. Both addresses are identified using i2cdetect and the IMU is detected by the PyPilot app. I’m also able to approve the PyPilot Signal K request. The issue I am encountering is when I try to reconnect the IMU only widow flicks back to disable with the message at the bottom of the page. I’ve tried several times with 32bit and 64bit and the result is the same. Would appreciate any help as to where I’m going wrong.
