2023-06-26, 10:42 AM
Dear all,
Im using the following setup:
RaspberryPi 4 with Openplotter in Headless mode with
connected.
As a Wlan-client (AP+Client onboard Mode) im using a Macbook and OpenCPN.
Incoming connection in OpenCPN (on the macbook) is TCP localhost port:10110
Im getting a signal from the AIS, the GPS.
Im not receiving any I2C Sensor-Data.
When I connect via VNC on the RaspberryPi and start OpenCPN there, Im getting all the Sensordata.
It seems so me, that I have so setup a additional incoming connection in OpenCPN on the Macbook. Which one is it?
Im using the following setup:
RaspberryPi 4 with Openplotter in Headless mode with
- AIS DaisyHAT
- USB GPS Dongle
- USB RS422 Adapter
- I2C Sensor: 10 DOF IMU-Sensor (BMP280 & MPU9255 combined) on top of the DaisyHAT
- MPU9255 with the PyPilot-Application in Openplotter
- BMP280 with I2C-Applicatipn in Openplotter
connected.
As a Wlan-client (AP+Client onboard Mode) im using a Macbook and OpenCPN.
Incoming connection in OpenCPN (on the macbook) is TCP localhost port:10110
Im getting a signal from the AIS, the GPS.
Im not receiving any I2C Sensor-Data.
When I connect via VNC on the RaspberryPi and start OpenCPN there, Im getting all the Sensordata.
- On the SignalK Server under "Data Connection" the Sensor IMU-Data from PyPilot is displayed
- As well as the Temp and Pressuredata coming from the I2C-Application.
It seems so me, that I have so setup a additional incoming connection in OpenCPN on the Macbook. Which one is it?