2023-07-10, 02:37 AM
I have a DST800 Triducer (NMEA 0183) that I'm attempting to connect to my OP V2. I purchased a USB to RS422 converter. I correctly connected the wires (R+ and R-). The Receive LED is flashing RED, and I have 13V going to the Transducer. The OP notices it in the serial tab. I connected it to serial K at 38400 Baud using the AUTO. I added it to OPEN CPN under connections. However, it was added as 4800 baud. However, there is no response to temperature, depth, or speed. BTW, I'm doing all of this in my office before I install. Serial GPS works perfectly on the RPI V3b+. I'm not very knowledgeable about this. I'm sure I'm missing something. Can somebody assist me?