Weathersensor data not appearing

[PaddyB]

Noob question: I am not seeing any data appear in OpenCPN although the NMEA debugger shows a continuous stream of data that appears to be correct. (See screenshot)

I've also tried getting this into SignalK but there is no debug tool so I removed the connection there and figured I focus on OpenCPN to start with. 

I've read through the old and new wiki and searched this forum. Any suggestions as to solve/troubleshoot this will be appreciated. Thanks!

its actually worth putting everything through signalk first which then send all nmea0183 it receives straight out again and there are various debugging tools.





the data fiddler is useful as well-



Your issue seems to be the message, $WIMWV,320,R,15.0,M,A*0B works but $PYMWV,308.04,R,0.00,N,A*3b doesn't 



where is your wind data coming from? PY sounds like pypilot? If the wind sensor is connected to pypilot it might be better to connect it to signalk first then end the data to pypilot from there.