This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Can anyone help me troubleshoot this issue?
I have a DST800 Triducer (NMEA 0183) that I'm trying to connect to my OP V2 using a USB to RS422 adapter. I have correctly connected the wires (R+ and R-), and the Receive LED flashes RED. The transducer is receiving 13V. The OP V2 recognizes the device in the serial tab, and I connected it to serial K using AUTO at 38400 Baud. However, when I added it to connections in OPEN CPN, it showed up as 4800 baud. Despite all this, I'm not getting any response for temperature, depth, or speed. It's important to mention that I'm testing this setup in my office before installing it. My RPI V3b+ works fine with the Serial GPS. I'm not very familiar with these processes, so I must be missing something. Can anyone help me troubleshoot this issue? Thank you!

Messages In This Thread
Can anyone help me troubleshoot this issue? - by DaveGraves - 2023-08-12, 12:09 PM

Forum Jump:

Users browsing this thread: 1 Guest(s)