|
Navtex
|
2018-10-26, 03:09 PM
(2018-10-26, 12:32 PM)PaddyB Wrote: Hi, I used node-red, it's not been set up for a while but just found the backup, basically a insert node sends "0x0D 0x0A $S 0x0D 0x0A 0x0D 0x0A" to a serial port connected to the navtex engine for entire memory, then another serial port reads the output and sends it to a file and a node red dashboard.Hi Thanks a lot for the code.  I will try it next weekend. Best regards Bernhard |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Navtex - by SkipperEarly - 2016-04-24, 09:05 AM
RE: Navtex - by PaddyB - 2016-04-27, 10:46 AM
RE: Navtex - by tkoning - 2016-04-29, 10:07 AM
RE: Navtex - by SkipperEarly - 2016-04-29, 07:24 PM
RE: Navtex - by PaddyB - 2016-04-29, 07:56 PM
RE: Navtex - by gniersma - 2016-11-20, 12:44 PM
RE: Navtex - by PaddyB - 2016-11-21, 06:52 AM
RE: Navtex - by ocina - 2018-10-24, 08:58 PM
RE: Navtex - by PaddyB - 2018-10-26, 12:32 PM
RE: Navtex - by ocina - 2018-10-26, 03:09 PM
RE: Navtex - by abarrow - 2018-10-26, 01:41 PM
RE: Navtex - by PaddyB - 2018-10-26, 02:18 PM
RE: Navtex - by abarrow - 2018-10-26, 06:24 PM
RE: Navtex - by PaddyB - 2018-10-27, 11:14 AM
|
