2023-11-05, 09:30 AM
Hello,
Iam new to OP, still learning. I have connected a fuel filter vacuum/pressure sensor via a ADS1115
The sensor operates at 0,5 to 4,5 Volts but I only see 4,006 Volts as maximum. Can this be adjusted with Gain ? and where do I access the Gain Adjustment ?
The sensor should be linear but is it possible to add Calibration points if not ? and where do I do it ?
Thanks in advance
Klaus
Iam new to OP, still learning. I have connected a fuel filter vacuum/pressure sensor via a ADS1115
The sensor operates at 0,5 to 4,5 Volts but I only see 4,006 Volts as maximum. Can this be adjusted with Gain ? and where do I access the Gain Adjustment ?
The sensor should be linear but is it possible to add Calibration points if not ? and where do I do it ?
Thanks in advance
Klaus