This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pypilot : Installation with hydraulic cylinder + clutch + rudder sensor
#15
Hello Murmure
Sean described his controllers very well in the store. They integrate the Arduino chip and also offer galvanic decoupling of the connection to the PI and power supply of the Arduino and the controller from 12V. They have nothing to envy of commercial pilots in terms of efficiency and CEM.
Every boat can find what it needs between the three versions proposed by Sean

https://pypilot.org/opencart/index.php?r...duct_id=51
Reply


Messages In This Thread
RE: Pypilot : Installation with hydraulic cylinder + clutch + rudder sensor - by Jean-Marc Douroux - 2024-04-10, 01:10 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)