This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › MacArthur HAT › How do I...?
MacArthur hat and pypilot motor controller

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
MacArthur hat and pypilot motor controller
pxNav Offline
Junior Member
**
Posts: 3
Threads: 1
Joined: Feb 2024
Reputation: 0
#1
2024-03-03, 08:39 PM
How to connect pypilot motor controller to the MacArthur hat? On the motor controller has +3.3V, tx, rx and gnd lines, I try to connect NMEA 0183 data flow. Is this possible at all or need to connect directly to the Rasperry pi?

I can't find any basic instructions anywhere, looks like documentation is before than MacArthur hat entered on market.
Find
Reply


Messages In This Thread
MacArthur hat and pypilot motor controller - by pxNav - 2024-03-03, 08:39 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)