This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Pi5, NVMe Base, OpenPlotter, MacArthur HAT - Build
Hi, it comes with the standoffs and the GPIO extender so that it sits in the right place. The active fan is smaller than other hardware/sockets on the Pi board so you should be good to go. It’s a great setup, really pleased with mine.

Since that video, more of the software has been updated now so everything that was working on my old Pi4 setup is now running on this new one. Really stable and very fast!

Messages In This Thread
RE: Pi5, NVMe Base, OpenPlotter, MacArthur HAT - Build - by Boatingbaileys - 2024-03-31, 10:40 AM

Forum Jump:

Users browsing this thread: 2 Guest(s)