2024-04-09, 05:36 PM
I found this diagram and I understand now how it works:
So I think I could connect all both Com. wires to ground, and the other 8 wires to ESP32 inputs.
However, I in order to do that I need to "duplicate" the connector so on one side stays connected to the electrical panel, and the other to the ESP32. But I don't know how this connector is called, so I don't know how to buy a "duplicator" (or splicer, or however this is called).
Any inputs on that?
So I think I could connect all both Com. wires to ground, and the other 8 wires to ESP32 inputs.
However, I in order to do that I need to "duplicate" the connector so on one side stays connected to the electrical panel, and the other to the ESP32. But I don't know how this connector is called, so I don't know how to buy a "duplicator" (or splicer, or however this is called).
Any inputs on that?