This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › Pypilot › General discussion v
Toothed pulley sources

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Toothed pulley sources
seandepagnier Offline
Moderator
*****
Posts: 2,665
Threads: 23
Joined: Jun 2016
Reputation: 89
#2
2024-04-23, 02:34 PM
It is possible to 3d print one, however my printer maxed out at 280mm and was slightly eccentric. I used hdt5m type belt.
Find
Reply


Messages In This Thread
Toothed pulley sources - by Beakster - 2024-04-21, 08:55 PM
RE: Toothed pulley sources - by seandepagnier - 2024-04-23, 02:34 PM
RE: Toothed pulley sources - by Sully - 2024-04-24, 06:23 PM
RE: Toothed pulley sources - by Sully - 2024-05-06, 02:02 PM
RE: Toothed pulley sources - by seandepagnier - 2024-05-06, 02:33 PM
RE: Toothed pulley sources - by SVHM - 2024-05-06, 03:39 PM
RE: Toothed pulley sources - by seandepagnier - 2024-05-06, 04:50 PM
RE: Toothed pulley sources - by MacKludger - 2024-05-06, 10:37 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)