Hi, thank you so much! After doing that the correct 2 devices (Wind and Speed) showed up I mistook some serial device on UART3 being my device.
I still cant seem to get anything in the data browser though, what is the correct way of setting up a NMEA0183 connection in SignalK? I set the baud rate to 4800 as its a converted Seatalk signal.
Im uncertain what to put in input and output event and what the data logging flag does
I still cant seem to get anything in the data browser though, what is the correct way of setting up a NMEA0183 connection in SignalK? I set the baud rate to 4800 as its a converted Seatalk signal.
Im uncertain what to put in input and output event and what the data logging flag does