Thanks for the swift reply, Sean. Appreciate your help.
Here's the output:
pi@openplotter:~ $ pypilot_calibration
failed to load pywavefront: Cannot connect to "None"
Unable to access the X Display, is $DISPLAY set properly?
Happy to pull from git and try again, but I need some help with the commands. Do I follow these steps?:
git clone https://github.com/pypilot/pypilot
sudo python3 setup.py install
Sean, I think I found the culprit. It's Wayland.
I did switch to Wayland (via the Openplotter settings app) since running Openplotter Headless was extremely laggy.
I have now switched back to X11 and the Accel and Compass screens are now working. Scope however and Settings remain blank.
Here's the output:
pi@openplotter:~ $ pypilot_calibration
failed to load pywavefront: Cannot connect to "None"
Unable to access the X Display, is $DISPLAY set properly?
Happy to pull from git and try again, but I need some help with the commands. Do I follow these steps?:
git clone https://github.com/pypilot/pypilot
sudo python3 setup.py install
Sean, I think I found the culprit. It's Wayland.
I did switch to Wayland (via the Openplotter settings app) since running Openplotter Headless was extremely laggy.
I have now switched back to X11 and the Accel and Compass screens are now working. Scope however and Settings remain blank.