2017-06-25, 03:57 PM
Greatings to you all! What a wonderful project I discovered! I really want to enjoy and get this OP with Raspberry running on my little boat.
To start, can please one of you experts confirm or deny, whether my thoughts in configuration are feasible, because I'm very new to all of this ?
I have a Simrad radio RS12 with NMEA 183 and 2000 interface. I also have a GPS antenna with NMEA 183 output which is
connected to my radio and works fine. I understand, to get the NMEA signals into OP (raspberry) I need an USB interface. Can I just connect
the data wires in parallel in order to feed both the radio and the USB interface (signals only in one direction),
or do I need a NMEA splitter ? Can you recommend one ?
Or is it better to utilize/filter the NMEA 2000 port of the radio and feed all data into the NK2 CAN USB adapter, but just for GPS ?
I actually only want to avoid a 2nd GPS antenna, because the one I have works fine and is high up in the mast.
Of course I prefer the NMEA0183 solution, if feasible. Thanks in advance for any feedback.
To start, can please one of you experts confirm or deny, whether my thoughts in configuration are feasible, because I'm very new to all of this ?
I have a Simrad radio RS12 with NMEA 183 and 2000 interface. I also have a GPS antenna with NMEA 183 output which is
connected to my radio and works fine. I understand, to get the NMEA signals into OP (raspberry) I need an USB interface. Can I just connect
the data wires in parallel in order to feed both the radio and the USB interface (signals only in one direction),
or do I need a NMEA splitter ? Can you recommend one ?
Or is it better to utilize/filter the NMEA 2000 port of the radio and feed all data into the NK2 CAN USB adapter, but just for GPS ?
I actually only want to avoid a 2nd GPS antenna, because the one I have works fine and is high up in the mast.
Of course I prefer the NMEA0183 solution, if feasible. Thanks in advance for any feedback.