This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › Node Red v
Connecting JSON from Ethernet device

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
Connecting JSON from Ethernet device
jim321 Offline
Moderator
*****
Posts: 800
Threads: 46
Joined: Jun 2017
Reputation: 25
#3
2018-01-05, 03:52 PM (This post was last modified: 2018-01-05, 09:30 PM by jim321.)
looks like you would need a crossover cable..

""Connect the DAEnetIP2 controller with your computer via UTP crossover cable.""
http://denkovi.com/Products/DAEnetIP2/Cross-over.JPG
http://denkovi.com/web-relay-board-8-cha...-daenetip2

https://www.google.com/search?q=crossove...e&ie=UTF-8
then in a terminal do an ifconfig to see if it got an ip address.

you need to learn NodeRED its not that hard.. freeboard has been taken out of the newest version of op..
Find
Reply


Messages In This Thread
RE: Connecting JSON from Ethernet device - by jim321 - 2018-01-05, 03:52 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)