This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › Documentation v
IC2 Pin Assignment for MacAuther Hat

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
IC2 Pin Assignment for MacAuther Hat
fun4all Offline
Junior Member
**
Posts: 12
Threads: 4
Joined: Sep 2024
Reputation: 0
#1
2024-11-06, 06:06 PM (This post was last modified: 2024-11-06, 06:20 PM by fun4all.)
Can someone please post the pin assignments for the QWIIC IC2 port on the MacAuther Hat.   There are 4 pins on the QWIIC connector and trying to figure out what pin goes to what pin on the IC2 devices.......... Im pacifically trying to install a couple INA219 Current Sensors and a couple Optocouplers.    The INA219 pins are  Vcc, Gnd, Sci, Sda, Vin-, Vin+
Find
Reply


Messages In This Thread
IC2 Pin Assignment for MacAuther Hat - by fun4all - 2024-11-06, 06:06 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)