This forum uses cookies
This forum makes use of cookies to store your login information if you are registered, and your last visit if you are not. Cookies are small text documents stored on your computer; the cookies set by this forum can only be used on this website and pose no security risk. Cookies on this forum also track the specific topics you have read and when you last read them. Please confirm whether you accept or reject these cookies being set.

A cookie will be stored in your browser regardless of choice to prevent you being asked this question again. You will be able to change your cookie settings at any time using the link in the footer.
OpenMarine › OpenPlotter › Bug Reports v
I2C service not running ...Work Around

Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Linear Mode
I2C service not running ...Work Around
Tom60 Offline
Junior Member
**
Posts: 28
Threads: 3
Joined: Jun 2023
Reputation: 0
#38
2026-04-08, 08:38 AM
Well I've purchased a new BME280 sensor and fitted it to the GPIO pins.  It's recognised at address 0x76 and shows pressure & humidity.  However it's still greyed out on the Signalk Dashboard.   
A new sensor hasn't solved the problem.  I'm not sure where to go from here?
Find
Reply


Messages In This Thread
RE: I2C service not running ...Work Around - by Tom60 - 2026-04-08, 08:38 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)