2016-11-28, 08:44 PM
I finally soldered up the MCP3008. I connected to the PI via spaghetti wire on the bottom of the prototype board, soldered to the bottom of the header pins. And it works! I can monitor the voltage of my house bank.
V0.8.0 up and running, and further studies (SPI I/F
|
« Next Oldest | Next Newest »
|
Messages In This Thread |
V0.8.0 up and running, and further studies (SPI I/F - by Didier B - 2016-04-26, 04:03 PM
RE: V0.8.0 up and running, and further studies (SPI I/F - by Sailoog - 2016-04-26, 07:03 PM
RE: V0.8.0 up and running, and further studies (SPI I/F - by Didier B - 2016-04-26, 09:43 PM
RE: V0.8.0 up and running, and further studies (SPI I/F - by Moorea - 2016-04-27, 07:19 PM
RE: V0.8.0 up and running, and further studies (SPI I/F - by Didier B - 2016-05-01, 10:09 AM
RE: V0.8.0 up and running, and further studies (SPI I/F - by Saqqara - 2016-11-27, 03:46 PM
RE: V0.8.0 up and running, and further studies (SPI I/F - by Sailoog - 2016-05-01, 08:31 PM
RE: V0.8.0 up and running, and further studies (SPI I/F - by holgerw - 2016-05-02, 08:28 AM
RE: V0.8.0 up and running, and further studies (SPI I/F - by Saqqara - 2016-11-28, 08:44 PM
|