Cant get autopilot data out

[e-sailing]

Well i did simulate it.
1. The problem is that you can get recursiv loops.
   So you need a different data stream to opencpn then the 10110 standard. To avoid loops this stream must have an ofilter=-EC***.
Normaly you wouldn't connect AP only for output. You also want data from the AP (heading, rudder). Then to keep AP happy don't throw all GP*** to it. Give him wind, (heading) and of course **RMB.
My setting is:
Net    localhost:10112  1        TCP            Input                  In:None, Out: None
Net    127.0.0.1:10110 1        UDP            Output                In:None, Out: Send RMB


In OP i deleted my AP out of Inputs or Outputs and pressed "Apply changes" then pressed "Advanced"
and searched at the end ot the file "###Manual settings". There i inserted
"
[tcp]
name=opencpn
direction=out
mode=server
ofilter=-EC***
port=10112

[serial]
name=ap
direction=both
optional=yes
ofilter=+EC***:+GPGGA:+GPRMC:+**MWV:+**V**:+**HDM:-all
filename=/dev/ttyOP_AP
baud=4800
"
I saved file and exit. Started openplotter and pressed "Restart" on "NMEA0183" page.
I restarted opencpn and made a route right clicked on the route and activated it.
Then i opened Inspector and watched ECRMBs between GP***...