2017-09-04, 07:42 PM
(This post was last modified: 2017-09-04, 07:51 PM by Alpenskipper.)
Hi!
I have the same problem with a 0.15 fresh installation. I always need to restart Signal K to make the GPIO input working after a reboot.
"startup restart" does not produce errors and Signal K is working after the command. Anyways, after a reboot I need to restart Signal K manually.
Martin
Update: As far as I can test from remote, a delay of 10 seconds in the startup tab did the job.
I have the same problem with a 0.15 fresh installation. I always need to restart Signal K to make the GPIO input working after a reboot.
"startup restart" does not produce errors and Signal K is working after the command. Anyways, after a reboot I need to restart Signal K manually.
Martin
Update: As far as I can test from remote, a delay of 10 seconds in the startup tab did the job.