2017-09-12, 05:47 PM
(This post was last modified: 2017-09-12, 05:58 PM by Alpenskipper.)
Good and bad news...
OP recognizes the automation pHat at once.
But I have no idea, how to configure...
I changes the SigK names and connected a battery with 5.18 volts to ADC 1. A voltage is measured, but far to high. The unconnected ADS2 shows 3 volts.
The openplotter_analog.conf looks like this.
The pHat already has a voltage divider integrated and can measure up to 24V directly.
Could you please help me with the .conf file?
Edit: It seems, the ADS input is measuring resistance, not volts.
OP recognizes the automation pHat at once.
But I have no idea, how to configure...
I changes the SigK names and connected a battery with 5.18 volts to ADC 1. A voltage is measured, but far to high. The unconnected ADS2 shows 3 volts.
The openplotter_analog.conf looks like this.
The pHat already has a voltage divider integrated and can measure up to 24V directly.
Could you please help me with the .conf file?
Edit: It seems, the ADS input is measuring resistance, not volts.