2017-12-29, 04:40 PM
Thats brilliant guys. Thanks.
Upgraded to V10 and then disabled AP and could connect to internet. Enabled AP and can see over VNC so that bit is sorted!
The next part....
I downloaded Openplotter Noobs to a 16GB card as I also wanted to store the charts (oeSENC charts from o-charts) and run Kodi from there too.
When I look at the card in finder on my Macbook, it shows a boot and a recovery disk but they are both full and less than 2GB. I looked at it using the disk utility and there are 2 unmounted partitions disk1s5 and disk1s7 but I cant see them to save anything to them.
How do I go about using these areas? Or do I have to store the charts and any other software externally?
Thanks again
Dave
Upgraded to V10 and then disabled AP and could connect to internet. Enabled AP and can see over VNC so that bit is sorted!
The next part....
I downloaded Openplotter Noobs to a 16GB card as I also wanted to store the charts (oeSENC charts from o-charts) and run Kodi from there too.
When I look at the card in finder on my Macbook, it shows a boot and a recovery disk but they are both full and less than 2GB. I looked at it using the disk utility and there are 2 unmounted partitions disk1s5 and disk1s7 but I cant see them to save anything to them.
How do I go about using these areas? Or do I have to store the charts and any other software externally?
Thanks again
Dave