Hi,
I have make a new thread for this problem:
MCP2515 on CE1 do not work at same time with moitessier hat.
(2.0.21 Pi 4)
I have find out following:
By adding:
dtoverlay=mcp2515-can1,cs=1,oscillator=16000000,interrupt=25
throug the CAN BUS App of openplotter the SPI with CE1 should be load.
says:
[ 4.689934] mcp251x spi0.1 can0: MCP2515 successfully initialized.
so far all right
but in the devicetree the SPI is called spidev0.0
I think that shoul make problems with Moitessier driver?
I have make a new thread for this problem:
MCP2515 on CE1 do not work at same time with moitessier hat.
(2.0.21 Pi 4)
I have find out following:
By adding:
dtoverlay=mcp2515-can1,cs=1,oscillator=16000000,interrupt=25
throug the CAN BUS App of openplotter the SPI with CE1 should be load.
Code:
dmesg | grep -i -E "(mcp|spi)"
says:
[ 4.689934] mcp251x spi0.1 can0: MCP2515 successfully initialized.
so far all right
but in the devicetree the SPI is called spidev0.0
I think that shoul make problems with Moitessier driver?