Hi all, I have a set of one wire sensors that just just left the building... There are seven of them (with reduced resistor to make them all work) and they are hooked up onto an ESP8266 running SigKsens and have been working flawlessly for a couple off weeks now.
Today they were all gone. I have not touched anything, and the voltage read from the analog port on the same ESP shows up with correct value. When I look at the sensor in my browser, they are there, but as seen in the image they all give value "null", or a simple dash in signal K.
Anyone experienced anything like it before? Typically - I was putting final touches on THIS part of my build today...
Today they were all gone. I have not touched anything, and the voltage read from the analog port on the same ESP shows up with correct value. When I look at the sensor in my browser, they are there, but as seen in the image they all give value "null", or a simple dash in signal K.
Anyone experienced anything like it before? Typically - I was putting final touches on THIS part of my build today...