2020-05-19, 12:23 AM
you just need to click the enable hardware uart button in openplotter serial settings and reboot.
OpenPlotter - PyPilot - TinyPilot
|
2020-05-19, 12:23 AM
you just need to click the enable hardware uart button in openplotter serial settings and reboot.
2020-05-20, 12:15 AM
(2020-05-19, 12:23 AM)seandepagnier Wrote: you just need to click the enable hardware uart button in openplotter serial settings and reboot. Thanks - found the button and yes that's a lot simpler but it still doesn't seem to work for me. So:
I really am not sure what I'm doing wrong.... Does that matter that ttyACM0 shows up as a device in the OpenPlotter serial list? I guess not as when I delete it the Arduino IDE can't find the port anymore. Thanks again for your help.
2020-05-24, 12:35 PM
To upload it is /dev/ttyAMA0 not /dev/tyACM0. You must press the reset button or repower the arduino exactly when you run the avrdude command to upload.
2023-02-19, 09:11 PM
(2020-05-12, 11:11 PM)rastam4n Wrote:I use PICAN-M, and it uses 8 ir 10 pins, is it possible change RPI pin or better for me in this situation use TinyPilot? probably i couldn't use the pin 8 and 10 for PICAN and Pypilot?(2020-05-12, 09:53 PM)DoubleDutch Wrote: Some very basic questions:
2023-02-20, 04:24 PM
there are other serial ports on the pi 4 and pi zero 2, but the other raspberry pi you would want to use pin 8 and 10. Its possible to use USB as well but I prefer hardware serial.
2024-02-02, 12:09 PM
(2023-02-19, 09:11 PM)badutis Wrote:(2020-05-12, 11:11 PM)rastam4n Wrote:I use PICAN-M, and it uses 8 ir 10 pins, is it possible change RPI pin or better for me in this situation use TinyPilot? probably i couldn't use the pin 8 and 10 for PICAN and Pypilot?(2020-05-12, 09:53 PM)DoubleDutch Wrote: Some very basic questions: I havce just received the High Power controller from Sean but colors or wires are differnet. Ayway, If I understand correcly I must CROSS TX and RX on the controller and the Pi Zero?. In the schematics of the controller pin labeled RX goes to the IN pin of the cpc5001, so I supose must be connected to the TX of the pi. Is it correct?
2024-02-02, 07:51 PM
What you said should be correct. I have put resistors so that if you were to wire it wrong there should not be any damage. I supply my motor controller and hats already wired so this would only apply if you were wiring a motor controller directly without the pypilot hat.
|
« Next Oldest | Next Newest »
|