2020-06-24, 11:14 PM
Thanks Lazzz! I would never have found that.
Now to figure out how to configure and use...
Now to figure out how to configure and use...
1W support openplotter 2
|
2020-06-24, 11:14 PM
Thanks Lazzz! I would never have found that.
Now to figure out how to configure and use...
2020-06-26, 01:57 PM
Hello,
Once installed as indicated by LAZZZ, restarts signalK. Then you go to / Server / Plugin config and you will see a line 'Raspberry-Pi 1-Wire' Click on it, validate the mention 'Active' and configure your device by giving its ID N ° and the SignalK key (without adding 'environment' in front. I need the outside temperature, I put the N ° ID of my probe and I write outside.temperature in the SignalK key section. (This key is read by Opencpn if you add the dashboard 'temp Air' for example) Cordialy
2021-01-17, 06:53 PM
Updated openplotter-gpio v2.1.0 with support for 1W sensors:
https://forum.openmarine.net/showthread....4#pid17814 |
« Next Oldest | Next Newest »
|